Process instrumentation · selection · supply · technical support | Middle East / Iran / SEA / EU Enquiry: WhatsApp / chat

Selection guide

How to select a flowmeter: electromagnetic vs vortex

A practical guide for engineers and buyers · Sutao Instrument technical team

Choosing between an electromagnetic and a vortex flowmeter usually comes down to one question: what is flowing through the pipe, and under what conditions? Get that right and the rest — size, material, output — follows. This guide walks through the decision in the order we use when we size a meter for a customer.

Short answer: use an electromagnetic flowmeter for conductive liquids (water, wastewater, slurry, acids, alkalis). Use a vortex flowmeter for steam, gas and clean liquids where conductivity is not a factor. If the medium is non-conductive and not steam or gas, talk to us — a different technology may be needed.

1. Start with the medium

The medium eliminates half the options immediately.

If you are unsure about conductivity, send us the medium and its concentration and we will confirm whether an electromagnetic meter will read reliably.

2. Confirm line size and flow range

Both meter types are commonly available from DN15 to DN300. The important thing is not the pipe size alone but the velocity at your normal and minimum flow. A meter that is too large for the actual flow will read poorly at the low end. Give us the normal flow, minimum flow and maximum flow — not just the pipe diameter — and we will check the velocity.

3. Check pressure and temperature

For liquids this is usually straightforward. For steam and gas it is critical: density changes with pressure and temperature, so the meter size and range depend on both. For billing-grade steam metering, add pressure and temperature compensation. Tell us the operating (not just design) pressure and temperature.

4. Decide the materials

The wetted parts must survive the medium:

Wrong material selection is the most common cause of early failure — it is worth confirming against the actual composition, concentration and temperature, not a generic fluid name.

5. Output, power and approvals

Most process applications use 4–20 mA, often with HART or Modbus. Confirm the power available at the site (24 VDC, 220 VAC, or battery). If the installation is in a hazardous area, tell us the zone classification and gas group — we will map it to the correct explosion-protection option before quoting. For EU water, gas or heat metering, check whether MID applies; for Russia/EAEU, check EAC pattern approval.

6. Installation conditions people forget

Comparison at a glance

CriterionElectromagneticVortex
MediumConductive liquids onlySteam, gas, clean liquids
Moving partsNoneNone
Typical accuracy*±0.5% of reading±1.0% liquid / ±1.5% gas & steam
Conductivity requirementYes (≥ ~5 μS/cm)No
Pressure lossNegligibleLow (bluff body)
Steam serviceNoYes
Slurry / dirty liquidGood fitNot ideal

* Typical figures for reference; final accuracy and range confirmed per model and site conditions.

Still deciding? Send us four things — medium, line size, flow range, pressure/temperature — and we will recommend a model and send the matching datasheet. Ask on WhatsApp →

Related pages